Table scheduling
I would say that thanks to Covid-19 I have had more time for the development. It was necessary to rewrite some parts of the code to be more efficient and so I could work with it better. Then I focused on the table scheduling and simulation.
I have created a control page which deals with the table scheduling. It is possible to set up the normal mode or simulation. The simulation allows time acceleration and choosing the times from – to.
The following video shows how it works. After startup, the time and date are set. Then the used table is shown. A simulation from 5 to 10 hours is started. Only channel 0 is connected out to the LEDs. Unfortunately, the camera does not permit fixing the parameters, so it is not possible to precisely record the light intenzity changes. But I think to have an idea it is sufficient. Where are the times of manual mode cameras?
